dreamgasra.blogg.se - Cisco virtual wireless lan controller add interface vlan

#Cisco virtual wireless lan controller add interface vlan driver
#Cisco virtual wireless lan controller add interface vlan software
#Cisco virtual wireless lan controller add interface vlan series

Additionally, LACP and PAgP are not supported on the controller.

Once the EtherChannel is configured as on at both ends of the link, it does not matter if the Catalyst switch is configured for either Link Aggregation Control Protocol (LACP) or Cisco proprietary Port Aggregation Protocol (PAgP) because no channel negotiation is done between the controller and the switch.

LAG requires the EtherChannel to be configured for the on mode on both the controller and the Catalyst switch.

#Cisco virtual wireless lan controller add interface vlan series

When a Cisco 5500 Series Controller LAG port is connected to a Catalyst 3750G or a 6500 or 7600 channel group employing load balancing, note the following: Both switch ports are assigned to the same channel group. The controller’s port 1 is connected to Gigabit interface 3/1, and the controller’s port 2 is connected to Gigabit interface 2/1 on the Catalyst 6500 series switch. A Cisco 4402-50 Controller is connected to two different Gigabit modules (slots 2 and 3) within the Catalyst 6500 Series Switch. Figure 4-10 shows this use of redundant modules.

Terminating on two different modules within a single Catalyst 6500 series switch provides redundancy and ensures that connectivity between the switch and the controller is maintained when one module fails.

With LAG enabled, the logical port on the Catalyst 3750G Integrated Wireless LAN Controller Switch and on each Cisco WiSM controller supports up to 150 access points.

#Cisco virtual wireless lan controller add interface vlan software

Cisco 5500 Series Controllers support LAG in software release 6.0 or later releases, Catalyst 3750G Integrated Wireless LAN Controller Switch.You can bundle all eight ports on a Cisco 5508 Controller into a single link.Virtual Switching System: wism switch switch_no module module_no controller controller_no qos-vlan-based Standalone: wism module module_no controller controller_no qos-vlan-based The commands that are equivalent to the mls qos-vlan-based command are as follows: Therefore, the VLAN-based QoS policy applied at the ingress of the SVI for wireless to wired traffic never polices any traffic coming out of the WiSM LAG that hits the SVI. All the previous 12.2(33)SXI releases, which support Auto LAG for WiSM only, such as 12.2(33)SXI, 12.2(33)SXI1, 12.2(33)SXI2a, 12.2(33)SXI3, and so on, do not have this WiSM CLI. To enable an ingress 元 VLAN-based policy on the SVI, you must enable a VLAN-based QoS equivalent to the mls qos-vlan-based command on the WiSM LAG. When the traffic comes out of the WiSM LAG (L2) and hits the Switch Virtual Interface (SVI) (元), the QoS policy applied is a VLAN-based policy that has no effect on the policing. Note When you apply a flow policer or an aggregate policer at the ingress of a Dynamic Interface VLAN for the Upstream (wireless to wired) traffic, it is not possible to police because the VLAN based policy has no effect and no policing occurs. Information About Multicast Optimization.Adding an Interface Group to a WLAN (CLI).Adding an Interface Group to a WLAN (GUI).Viewing VLANs in Interface Groups (CLI).Adding Interfaces to Interface Groups (CLI).

Adding Interfaces to Interface Groups (GUI).

Configuration Example: Configuring AP-Manager on a Cisco 5500 Series Controller.

Creating Multiple AP-Manager Interfaces (CLI).

Creating Multiple AP-Manager Interfaces (GUI).

Creating Multiple AP-Manager Interfaces.

Information About Multiple AP-Manager Interfaces.

Configuring Multiple AP-Manager Interfaces.

Configuring Neighbor Devices to Support Link Aggregation.

Verifying Link Aggregation Settings (CLI).

Choosing Between Link Aggregation and Multiple AP-Manager Interfaces.

Changing the Cisco USB Systems Management Console COM Port to an Unused Port.

#Cisco virtual wireless lan controller add interface vlan driver

Installing the Cisco Windows USB Console Driver.Using the Cisco 5500 Series Controller USB Console Port.Information About Dynamic AP Management.Configuring Service-Port Interfaces (CLI).Configuring Service-Port Interfaces (GUI).Information About Service-Port Interfaces.Configuring the AP-Manager Interface (CLI).Configuring the AP-Manager Interface (GUI).Information About the AP-Manager Interface.Configuring the Management Interface (CLI).Configuring the Management Interface (GUI).Information About the Management Interface.Information About Distribution System Ports.